Tools

Gamepad & Button Box Tester

Test your wheel, pedals, handbrake, button box or controller in the browser. Every button and axis shows live, with the full range of each axis, any jitter while it's still, and switch bounce on buttons – ideal for checking a home-made Arduino or Leo Bodnar build. Nothing is installed and nothing leaves your computer.

Plug in your device and press any button

For privacy, browsers only show a controller once you've pressed a button on it while this page is open. Wheels and pedals count too – press a wheel button or move a pedal and press a button.

Works best in Chrome or Edge on Windows; Firefox is less reliable. If a device doesn't appear, close its maker's software (some pedal and wheel apps keep the device to themselves) and press a button again.

Device

Maker–
USB VID : PID–
Buttons0
Axes0
Mapping–
Updates / sec–
Connected–

ButtonsLit = pressed · small number = presses

Orange outline = the button fired again within 40 ms of being let go (switch bounce). The odd one is normal on cheap switches; lots of them point to a worn switch or a missing debounce in your firmware.

AxesShaded = range seen

This device has no axes.

Wheel & pedals

–
–
Clutch
–
Brake
–
Throttle
Steering° Throttle Brake Clutch

Pick which axis is which (move a pedal and watch the Axes list). Pedals and wheels on separate USB connections show as separate devices – switch between them above.

Event log

Press each physical button in turn to see which number it is – handy when wiring a button box.

Frequently asked questions

Why doesn't my wheel or button box show up?

Browsers only list a controller once you press one of its buttons while the page is open, so press any button. If it still doesn't appear, check it shows in Windows (search for "Set up USB game controllers"), close other programs that might hold it exclusively, and try Chrome or Edge.

Why are my button numbers one out?

The browser counts buttons from 0, while Windows' Game Controllers panel and most sims count from 1. The tester numbers from 1 by default to match; untick Number from 1 to see the browser's own numbers.

Can I test an Arduino or Leo Bodnar button box?

Yes. Any board that shows up in Windows as a game controller works, including Leo Bodnar BBI-32 and BBI-64 boards and Arduino Leonardo, Micro or Pro Micro boards running a joystick library. Press each button in turn and watch the event log to check the wiring and the button numbers.

What does switch bounce mean?

When a mechanical switch closes, its contacts can bounce and register two or more presses in a few milliseconds. The tester flags a press that comes within 40 ms of the button being released. The odd one is normal; frequent bounces suggest a worn switch or that your firmware needs debouncing.

How do I check my pedals reach 0% and 100%?

Press each pedal all the way down and let it go. The shaded part of the axis bar shows the range seen, and a tick appears once it covers the full travel. Pick the pedal's axis under Wheel and pedals to see it as a percentage, and tick Invert if it reads backwards. Use Reset stats to start again.

What does the noise figure show?

While an axis is still, the tester measures how much its reading wobbles over about a second. A small figure is normal; a large or growing one can point to a worn potentiometer, a loose connection or electrical interference, which can show up as a twitchy wheel or a brake that never quite reads zero.

Does it work with force feedback wheels?

It shows the wheel's buttons, steering and pedal axes. Browsers can't send force feedback to a wheel, so the effects themselves can't be tested here; the rumble test only works with Xbox-style controllers.

Is anything sent to TSR?

No. The tester runs entirely in your browser; the readings from your devices never leave your computer.